ZTE ZXA10 C600

System Architecture

• Network Processor (NP) + CLOS switch fabric architecture
• Support control and forwarding planes separate
• Support ISSU and NSR
• SDN ready, support Netconf/YANG, VXLAN

Access Features

• 272/256 GPON, 10G PON, Any-PON, or Combo PON ports
• Three generations of PON technologies and directions in one platform
• Support full services and scenarios access, such as big video, FMC, network re-architecture, etc.

Hardware Features

• ETSI 21" shelf: 23 slots, IEC19" shelf: 21 slots
• 17 slots (21") / 15 slots (19") for universal line cards
• 2 slots for switch & control cards
• 2 slots for power cards
• 1 slot for clock synchronization card
• 1 slot for FAN module
• Switching capacity of backplane bus: 14 Tbit/s
• Switching and control card: 3.6 Tbit/s
• System switching capacity: 7.2 Tbit/s
• 16 * 10GE uplink per card
• 8 * 10GE uplink per card

Subscriber Card Density

• GPON card: 16 ports per card
• XG-PON card: 16 ports per card
• XGS-PON card: 16 ports per card
• XG-PON & GPON Combo PON card: 16 Combo PON ports per card
• XGS-PON & GPON Combo PON card: 16 Combo PON ports per card
• Any-PON card: 16 Any-PON ports per card
• 10G-EPON card: 16 ports per card
• 10GE P2P card: 16 ports per card
• GE/FE P2P card: 24/48 ports per card

PON Features

• GPON is compliant to ITU G.984.x
• Support up to 1:128 optical split ratio
• Support OLS
• XG-PON is compliant to ITU G.987.x and G.988
• Support up to 1:256 optical split ratio
• Type B/C optical link protection
• Support FEC
• Support AES-128
• XGS-PON is compliant to ITU-T G.9807.1 and G.988

L2/L3 Features

• Access control: MAC filtering, ACL
• L2-port: physical Ethernet ports, logical Vports and aggregation ports
• Support L2 services and TPID configuration
• VLAN: 1:1 VLAN, N:1 VLAN, flexible QinQ, VLAN bridge, TLS VLAN, M-VLAN, VLAN reuse
• 512K MAC address, MAC address management, permanent MAC, MAC address aging/learning/query/number limit
• Uplink protocol: STP/RSTP/MSTP, LACP
• Basic routing: unicast routing forwarding, static route, IP based load balance, ECMP
• Dynamic routing: RIPv1/v2, OSPFv2, BGP4, IS-IS v2, Graceful Restart, MD5, etc.
• DHCPv4: DHCP relay/proxy/snooping, Option 82, Option 60
• L3 interfaces: VLAN L3 routing, Loopback
• ARP: ARP protocol, ARP Proxy
• IPv6 basic features and ND
• Support BFD for IPv4/IPv6 routing protocol, including static/OSPF/ISIS/BGP

QoS Features

• Queue & scheduling mechanism: SP, WRR/DWRR, and SP+WRR
• DSCP labeling and relabeling
• Traffic statistics
• H-QoS
• Stream classification, rate limiting, shaping and priority setting
• Congestion Avoidance: tail drop, color-based RED, WRED
• Configuration of CIR/PIR/CBS/PBS/CM, TrTCM (Two Rate Three Color Marker)

Security Features

• Broadcast/multicast flooding rate limitation
• Downstream ARP filtering
• Forwarding panel protocol packet rate limit
• DHCP anti-spoofing
• Anti-DoS attacking
• ARP/IP anti-spoofing
• IP Source Guard
• Basic ACL and IPv6 ACL
• DHCP service security
• MAC address anti-drifting
• Port isolation: Uplink port/User port
• Broadcast packets separation based on VLAN
• L4 port disable
• CPU protocol packet rate limit and scheduling

OAM Features

• Management protocol and interface: CLI, Telnet/SSHv2, SNMP v1/v2/v3, IGMP/MLD proxy/snooping model
• Performance statistic and diagnosis
• Remote firmware download and upgrade
• Environment detecting, control and alarm
• Ethernet OAM: 802.1ag
• System fault auto-recovery and performance detection

Multicast

• IGMP snooping, proxy, router (v1/v2/v3)
• MLD v1/v2
• MVLAN: 4K Multicast VLAN
• Multicast snooping/proxy, router modes
• Enabling and disabling protocols globally or based on VLAN
• ASM/SSM mode based on IGMPv3 and MLDv2
• Less than 20 ms channel zapping delay
• SCB multicast forwarding and L3 multicast forwarding
• PIM-SM, PIM-SSM

VxLAN

• RFC7348
• Learning/aging MAC and VTEP IP
• Multiple AC type: port (PON port, vport), S-Vlan, S-Vlan+C-Vlan
• Support IPv6
• VTEP port associated IGMP
• ARP suppression
• VLAN configuration
• Status reporting
• Information query
• Static MAC configuration
• ARP suppression configuration

Environment

• Operating temperature: -40 °C ~ 65 °C for overall unit
• Starting up temperature: ≥ -25°C
• Operating humidity: 5% ~ 95%, non-condensing
• Altitude: ≤ 4000 m
• Air pressure: 70 kPa ~ 106 kPa

Power Supply

• Working voltage: -48 V (±20%), or -60 V (±20%)

Dimensions

• 21" shelf: 486.1 mm (H) * 535 mm (21") (W) * 288.5 mm (D)
• 19" shelf: 486.1 mm (H) * 482.6 mm (19") (W) * 288.5 mm (D)
• 21" empty shelf: 21 kg, full configuration: < 58 kg
• 19" empty shelf: 18 kg, full configuration: < 52 kg